Halloween Crow
por Dan en Thingiverse
This crow is in 4 pieces that are designed to be sliced and printed in "vase mode". The crow is about 18" (45cm) long when assembled. The largest section that you will need to print is about 7.25" (19cm) tall and about 5" (13cm) wide. I printed this in black PLA and used super glue to attach the...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Dan.
Archivos (4)
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 26,164
- Publicado
Sobre este modelo
This crow is in 4 pieces that are designed to be sliced and printed in "vase mode". The crow is about 18" (45cm) long when assembled. The largest section that you will need to print is about 7.25" (19cm) tall and about 5" (13cm) wide. I printed this in black PLA and used super glue to attach the sections. The eye holes were created with a dremmel tool and the red leds were added with hot glue.
Descripción original del autor, publicada en Thingiverse.
