Gweike G2 Fold-Away Camera Frame (ELP 8MP USB)

A fold-away mount that puts an ELP 8MP USB camera right over the center of the lens on a Gweike G2 fiber laser. It clips on using the same interface as the shield clips, so there's no drilling or modding. Because the camera sits at the lens center, camera calibration in LightBurn comes out accurate. I've tested it on my own machine and it's spot on. Fits: Gweike G2 20W, 30W and 50W, used with LightBurn. WARNING: Fold the camera away before you run a job. If you forget, the laser can burn the back of the camera. Printed parts: - foldaway_frame.stl - foldaway_cradle.stl - foldaway_pin.stl (hinge pin)

Hardware: - ELP 8MP USB camera Camera: https://www.amazon.com/dp/B00WFQOTM2 Alternate (if the first is out of stock): https://www.amazon.com/dp/B00KA7WSSU - 7 disc magnets, 5 mm diameter x 2 mm thick, glued in. Fit each mating pair with opposite poles facing. Magnets: https://www.amazon.com/dp/B0G25BFHT8 - Hinge pin: the printed pin, a 3 mm steel rod, or an M3 x 25 screw - 2 M2 x 4 screws to hold the camera board - Super glue or epoxy for the magnets - The camera's USB cable snaps into the clip on the cradle.

Print settings: Standard PLA+ settings with supports. Nothing special.