Guitar Wall Hanger – Wall Mount for Electric and Acoustic Guitars
This is a wall hanger for guitars: the neck slides between the two prongs and the headstock rests on them; raised tips stop the guitar from sliding off. Glue a strip of felt or thin rubber onto the prongs to protect the finish.
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Layerline.
Archivos (1)
- model.zip ZIP
- Categoría
- Hogar
- Formatos
- ZIP
- Descargas
- 1
- Publicado
Sobre este modelo
This is a wall hanger for guitars: the neck slides between the two prongs and the headstock rests on them; raised tips stop the guitar from sliding off. Glue a strip of felt or thin rubber onto the prongs to protect the finish.
Opening 52 mm, 80 mm from the wall
Wall plate 74 × 90 mm with two countersunk screw holes
Prints in the orientation it is used in (arm on the bed, wall plate up) – no supports
Print in PETG with 5 walls and 50 % infill and screw it into a stud or with wall plugs. Some nitro finishes react with rubber – use felt for vintage guitars.
This is the free basic version. The complete set is "Guitar Wall Hangers – Wall Mounts for Guitar, Bass and Ukulele" – you'll find it in the Layerline shop on Cults3D.
Descripción original del autor, publicada en Cults3D.
