GT Bikes U-Brake Cable Splitter
por Christen Gorny en Thingiverse
Older GT Mountainbikes with u-brake in the rear uses a little plastic thingie to route the cable triangle around the seattube. This is a replacement for he often missing part :). Fits 28,6mm seattubes and uses a M4 bolt with 7mm nut. Best way to print is with supports, thin layers (0.1) and thicker.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Christen Gorny.
Archivos (1)
- Categoría
- Varios
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Older GT Mountainbikes with u-brake in the rear uses a little plastic thingie to route the cable triangle around the seattube. This is a replacement for he often missing part :). Fits 28,6mm seattubes and uses a M4 bolt with 7mm nut. Best way to print is with supports, thin layers (0.1) and thicker walls (like 6 layers for vertical means a very strong clamp!)
Descripción original del autor, publicada en Thingiverse.
