GRIP COURT - Print-in-Place Tennis Overgrip Box

Keep your overgrips organized with a mini tennis court in your racket bag. GRIP COURT is a hinged box that holds 4 rolled tennis overgrips, two on each side of a little white net. The floor of the box is a full tennis court, with doubles and singles lines, service boxes and centre marks printed in white, and the lid carries an engraved "Let's Play!". Prints in one piece, no assembly - The box, lid, hinge and latch come off the plate already joined. The hinge and the latch pivot use 45-degree cone joints that are printed in place, so there are no pins, no filament pieces and nothing to glue.

- The joints are captive: once printed, the lid and the latch cannot come off.

- The net is a separate small part. It slides into two grooves in the side walls.

- No supports needed.

Snap latch The latch hooks under a ridge on the front of the box and clicks into two small side lugs, so the box stays closed in a bag. Size - Closed: 113 x 61 x 41 mm

- Each side of the net: 53 x 56 mm, 32 mm deep

- Holds 4 standard rolled overgrips (tested with Wilson Pro Overgrip). They sit in the base, the lid is shallow.

Print profiles - PLA - 2 colours - AMS, all printers. Box in your colour, court lines and net in white PLA. About 2 h 10 min, 85 g.

- TPU for AMS + white PLA - dual nozzle (X2D, H2D). Soft, grippy box in Bambu TPU for AMS on the left nozzle, court lines and net in white PLA on the right nozzle, no filament swaps. About 2 h 07 min, 79 g TPU + 2 g PLA. This is the version in the photos.

Printing tips - The box prints opened flat and placed diagonally on the plate so it fits 256 mm beds. Please do not rotate it.

- After printing, open the lid and the latch firmly once to free the joints.

- Drop the net into the two grooves in the middle of the box.

- Choose any colour for the box: clay, green, light blue and dark blue all look great as a court.

If you like it, please leave a Boost and post a Make with your court colour!