Gridfinity battery holders
por Dan Forever en Thangs
This is a rebuild of the battery holders by Pestilence204 (https://social.thangs.com/m/103178) and FirstSurvivor (https://social.thangs.com/m/62323) using Gridfinity Rebuilt (https://github.com/kennetek/gridfinity-rebuilt-openscad)
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Dan Forever.
Archivos (4)
- gridfinity-batteries-aa-1x2.stl STL · 807 KB
- gridfinity-batteries-aaa-1x1.stl STL · 553 KB
- gridfinity-batteries-aaa-1x2.stl STL · 1,0 MB
- gridfinity-batteries-aa-1x1.stl STL · 444 KB
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 519
- Publicado
Sobre este modelo
This is a rebuild of the battery holders by Pestilence204 (https://social.thangs.com/m/103178) and FirstSurvivor (https://social.thangs.com/m/62323) using Gridfinity Rebuilt (https://github.com/kennetek/gridfinity-rebuilt-openscad)
If you grab the source files in OpenSCAD, you can create any arbitrarily sized container (you can also adjust the height!)
Since they're made using openscad-rebuilt, they have the added benefit of no spaghetti in the magnet holes (pits?).
These particular models were exported from the openscad project (which you can find at: https://github.com/DanForever/gridfinity-rebuilt-openscad
They were made with the following settings: battery wiggleroom: 0.30 battery spacing: -0.15 battery z offset: 1 gridz: 3
Descripción original del autor, publicada en Thangs.
