GoPro Time Lapser
por Fernando Rossi en Thingiverse
Materials needed: 1) Kitchen Timer - Got an super-cheap Egg Shaped timer. 2) A 608 bearing (or print one) The reduction ratio is 4:1, so in 1h of time lapse, the came will rotate ~ 90 degrees (take this in mind not focusing the object in the start of the time lapse). Instructions: Pull the top part.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Fernando Rossi.
Archivos (4)
- Categoría
- Tecnología
- Formatos
- STL, WATCH[1
- Descargas
- 19,396
- Publicado
Sobre este modelo
Materials needed: 1) Kitchen Timer - Got an super-cheap Egg Shaped timer. 2) A 608 bearing (or print one) The reduction ratio is 4:1, so in 1h of time lapse, the came will rotate ~ 90 degrees (take this in mind not focusing the object in the start of the time lapse). Instructions: Pull the top part of the eggtimer apart. Release the bottom screw and mount the internal mechanism in the base section. Secure with the screw.
Descripción original del autor, publicada en Thingiverse.
