UV LED USB Glowing Mushrooms Lamp!

Printed in glow filament, charged with USB powered UV or blue LEDs, you get a low power night light! You need a USB cable to chop the end off, 3 resistors, 3 LEDS, UV or blue will work, spare wire and some soldering skills/tools. You can wire in more than 3 LEDs to light the thing up a lot, a 5v USB cable can take more than ten 3 or 5mm LED easy. Wire them in parallel (a resistor each, or two of the same LED per resistor**), so if one goes out the rest stay lit. Prints with FDM printer just fine, no supports, use glow in dark filament/UV LED if you want the glow effect. Use a clear filament if you just want a lamp with LEDs. Pieces should snap together, glue if needed. There are 3 different sized mushroom caps, you need one of each. you cannot print and fit 3 large on the stems. If you're feeling artistic, paint the tops with some colour! Send a make photo! Drop a like/heart! Drop in an arduino digispark ATTiny85 and you can program 3-6 LEDs to do whatever you like. Maybe to fade up to full brightness when plugged in and power off in ~10 mins. Perhaps to power on LEDs every ~45 mins for ~5-10 mins to keep the glow up. (You can't use USB+- pins for USB data and LED power at same time) **mixing different colour LEDs on the same resistor doesn't work, path of least resistance...