Glove80 Perch

A one-piece desk frame that tents a Glove80 at 22° and holds a phone between the keyboard halves. Four angled sockets locate the rear inner and thumb-cluster feet; the outer feet rest on the desk. The phone cradle sits toward the rear to leave room around the thumb clusters. It has a split front lip, a rear cable path, and a small recessed mark on the backrest. Fit - Frame: approximately 179 × 118 × 56 mm; fits a 220 × 220 mm bed. - Sockets: 12.5 mm openings, 6 mm deep. Measure your feet or leg adapters before printing. - Phone preview: based on an estimated 84 × 15 × 168 mm Pixel 9 Pro XL with a Peak Design case. Check your own case and charging plug; the phone rests about 4.5 mm above the desk. Printing Print flat in PLA with a 0.4 mm nozzle. My suggested starting settings are 0.20 mm layers, 4 perimeters, 5 top and bottom layers, and 15% gyroid infill. No supports are needed. Add a brim if the foot pads lift. Also see my Go60 Perch https://www.printables.com/model/1881381-go60-perch.