Gingerbread House Kit Card – Snap-Out

Gingerbread kit Highlights

- Lights up: lift the house off the base and add an LED tealight up to 38 mm wide.

- No tools: connections are designed to snap free by hand.

- No glue: numbered pieces slot together. Glue if you want, but optional.

- No AMS needed: two colors with one manual filament change.

- Includes two trees, a snowman and a gingerbread figure.

Size

- Kit card: 175 × 172 × 2.4 mm—fits the A1 mini.

- Assembled: approximately 62 × 68 × 73 mm.

Printing PLA, 0.4 mm nozzle and 0.2 mm layers, including the first layer. AMS: Use the AMS profile, with brown assigned to the base and white to the details. The printer changes color automatically after the nine brown layers. NO AMS: Load brown filament and use the NO AMS profile. The printer pauses after the brown layers reach 1.8 mm, before starting the white details. Unload brown, load white, and purge until it comes through clean. Then resume printing. Assembly

- Let the card cool completely. Support the frame near each connection and gently rock the pieces free.

- Fit side walls 3 and 4 into front gable 1, decoration facing outward. Fit back gable 2 onto the remaining tabs.

- Place the house on base 7. Attach roof 5, then 6, overlapping the strip at the ridge.

- Join chimney pieces 8 + 10 and 9 + 11 into two L-shaped pairs. Bring the pairs together diagonally, then lower the completed chimney onto its roof seats.

- Put trees 12 and 13 in the outer front slots, person 15 in the left middle slot and snowman 14 in the right middle slot.

- Lift off the house, place the LED tealight in the circular recess and replace the house.

Use LED tealights only.

I hope you all get a merry christmas. Boost MeConsider boosting if you like this print. It means the world 🫶