Gingerbread House Corner Jig – Holds the Walls at 90° While the Icing Sets
This is a corner jig for building gingerbread houses: it hugs the outside corner of two walls and keeps them square while the royal icing sets. A round relief in the corner leaves room for the icing bead, so the jig doesn't get glued on, and the fin on the back is a handle and a foot.
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Layerline.
Archivos (1)
- model.zip ZIP
- Categoría
- Hogar
- Formatos
- ZIP
- Descargas
- 0
- Publicado
Sobre este modelo
This is a corner jig for building gingerbread houses: it hugs the outside corner of two walls and keeps them square while the royal icing sets. A round relief in the corner leaves room for the icing bead, so the jig doesn't get glued on, and the fin on the back is a handle and a foot.
74 × 74 mm, 50 mm high – for walls up to about 10 cm high
Print four, one for each corner of the house
Prints upright without supports
Use food-safe filament; the jig only touches the outside of the baked walls.
This is the free basic version. The complete set is "Gingerbread House Assembly Jigs – Corner Jigs in 3 Heights and Wall Braces" – you'll find it in the Layerline shop on Cults3D.
Descripción original del autor, publicada en Cults3D.
