Gimbal Belt Support for DJI Ronin RS 2

A hip/belt support cup for the DJI Ronin RS 2 gimbal. Rest the bottom of the gimbal handle in the cup to take the weight off your arms during long shots, walk-and-talks and event filming. HOW IT WORKS: A flat plate (124 x 72 mm) threads onto a 50 mm belt or strap through two slots. The cup pivots on an M6 bolt, so it tilts forward and back. Tighten the bolt to set the friction. An optional TPU liner adds damping and fits handles thinner than 40 mm. HARDWARE: 1x M6 x 50 mm socket head bolt (DIN 912), 1x M6 nut (nylon lock nut recommended), 2x M6 washers, a 50 mm wide belt or strap. PRINTING: Plate and cup are on one plate, no supports needed. Plate prints flat, cup prints on its flat pivot base with the opening up. Recommended PETG or PET-CF, 0.20 mm layers, 6 walls, 40% infill. Liner: TPU 95A. A brim around the cup is optional for extra adhesion. ASSEMBLY: Put the bolt through the countersunk side of the plate lugs and the cup pivot, drop the nut into the hex pocket on the other side and tighten until the cup holds its angle. Thread your belt: from outside through one slot, under the plate (against your body) and out through the second slot. Cup inner diameter is 41.5 mm. Please check the bottom of your gimbal handle before printing.