Geared smartphone holder
por Robert Lorincz en Thingiverse
Hi this is one of the cool gadgets I designed over Sunday, Geared phone holder, you can adjust the tilt of your phone. Update: Included two new holder variants for landscape phone position. Base without CT letters and a Base v2 version with tighter tolerances. Base v1 Lose version has additional...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Robert Lorincz.
Archivos (14)
- Base.3mf 3MF · 329 KB
- Holder.3mf 3MF · 792 KB
- Base.stl STL · 1,2 MB
- Holder.stl STL · 3,3 MB
- Base_V2_Tight.3mf 3MF · 330 KB
- Base_V2_Tight.stl STL · 1,3 MB
- Holder_V3_Landscape_Euro.3mf 3MF · 1002 KB
- Holder_V3_Landscape_Euro.stl STL · 4,0 MB
- Base_V1_Lose.3mf 3MF · 288 KB
- Base_V1_Lose.stl STL · 1,1 MB
- Holder_V2_Landscape.3mf 3MF · 818 KB
- Holder_V2_Landscape.stl STL · 3,4 MB
- Geared_PhoneHolder_V2.step STEP · 11,4 MB
- Geared_PhoneHolder_v2.f3z F3Z · 5,0 MB
- Categoría
- Tecnología
- Formatos
- 3MF, STL, STEP, F3Z
- Descargas
- 28,213
- Publicado
Sobre este modelo
Hi this is one of the cool gadgets I designed over Sunday, Geared phone holder, you can adjust the tilt of your phone. Update: Included two new holder variants for landscape phone position. Base without CT letters and a Base v2 version with tighter tolerances. Base v1 Lose version has additional 0.1mm clearance for easier fit. The bigger gap allows sliding the pieces together more easier. The models I printed with the following settings: Nozzle: 0.4mm Layer: 0.5mm width / 0.25mm height 4 top & bottom layers 2 walls, 10% infill. Hint: The two pieces are sliding together from the side. Enjoy!
Descripción original del autor, publicada en Thingiverse.
