Geared Phone Stand
por Jackson Farhat en Printables
This is a phone stand that you can adjust with a knob on the side.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a Jackson Farhat.
Archivos (12)
- Phone Holder Gear.step STEP · 2,9 MB
- Middle Piece.step STEP · 13 KB
- Side Plate.step STEP · 267 KB
- Bottom Piece.step STEP · 19 KB
- Bottom Gear.step STEP · 2,3 MB
- Hand Hold.step STEP · 224 KB
- Phone Holder Gear.stl STL · 296 KB
- Hand Hold.stl STL · 166 KB
- Side Plate.stl STL · 141 KB
- Bottom Piece.stl STL · 45 KB
- Middle Piece.stl STL · 30 KB
- Bottom Gear.stl STL · 962 KB
- Categoría
- Repuestos
- Formatos
- STEP, STL
- Descargas
- 1
- Publicado
Sobre este modelo
I created a geared phone stand after seeing a few designs around printables, but I wanted to make my own. It uses two herringbone gears to adjust the angle that the phone is at and you can lay your phone vertical or horizontal on it. It requires M3 screws to mount all the pieces together.
Assembly Instructions:
1. Take one of the Side Plates, the Hand Hold, and the Bottom Gear. Place the Bottom Gear's axle into the plate and place the Hand Hold on the the other side and screw an M3 screw through the knob into the Bottom Gear's Axle. (Marked by the yellow ring) 2. Screw the Bottom Piece into the plate with the Bottom Gear in it with all the corresponding screws. 3. Place the Phone Stand with the gear on the back 4. Place the Middle Piece through the Phone Stand Gear and screw it into the side plate (be sure that the slight slant is pointed toward the Bottom Gear)
5. Screw the other slide plate in to all the screw holes.
Descripción original del autor, publicada en Printables.
