Gap test print pieces for in-place printing
por Paul Naude en MyMiniFactory
These are gap test print pieces created from the "Fidget Cube Remix" by @walterhsiao.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Paul Naude.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- 3MF
- Descargas
- 335
- Publicado
Sobre este modelo
These are gap test print pieces created from the "Fidget Cube Remix" by @walterhsiao.
When printing parts that should not be fused together, it is best to test different gap designs first, since you can waste a lot of material and time if the parts were fused together or fit too loose.
The test pieces can be used to identify the best design gap for a specific filament and print setup that allow the parts to move without being too loose.
NB: Do not print supports since they may prevent movement if they remain inside the model.
Descripción original del autor, publicada en MyMiniFactory.
