Fully printable PCB vise
por Robert en Thingiverse
Pretty self explanatory, it's a vise to hold PCBs steady when you are soldering your components. The ball joint design gives you a fair bit of movement to position your work where it is most comfortable. The main drive screw has reverse threads on one side to make the jaws clamp your PCB right in...
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Robert.
Archivos (13)
- pcb_vise_v2-Base.STL STL · 326 KB
- pcb_vise_v2-Bracket.STL STL · 840 KB
- pcb_vise_v2-Drive_screw.STL STL · 8,7 MB
- pcb_vise_v2-Left_jaw.STL STL · 854 KB
- pcb_vise_v2-Right_jaw.STL STL · 854 KB
- pcb_vise_v2-Lock_screw.STL STL · 2,5 MB
- pcb_vise_v2-Stopper.STL STL · 103 KB
- pcb_vise_v2-Swivel.STL STL · 594 KB
- pcb_vise_v2-Thumb_screw.STL STL · 1,2 MB
- pcb_vise_v2-drive_screw_2parts_right.STL STL · 5,5 MB
- pcb_vise_v2-drive_screw_2parts_left.STL STL · 5,1 MB
- pcb_vise_v2-Bracket_2parts-bracket_right.STL STL · 432 KB
- pcb_vise_v2-Bracket_2parts-bracket_left.STL STL · 429 KB
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 72,442
- Publicado
Sobre este modelo
Pretty self explanatory, it's a vise to hold PCBs steady when you are soldering your components. The ball joint design gives you a fair bit of movement to position your work where it is most comfortable. The main drive screw has reverse threads on one side to make the jaws clamp your PCB right in the middle of the vise. The base has a few square holes for magnets to keep it steady on your workbench. The vise can hold PCBs with a maximum width of 10cm.
Descripción original del autor, publicada en Thingiverse.
