FPV Simulator thumb-stick
por benxfactor en Printables
I modeled some thumb-sticks for my Xbox one controller for Lift off; a FPV drone simulator.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a benxfactor.
Archivos (4)
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 647
- Publicado
Sobre este modelo
I modeled some thumb-sticks for my Xbox one controller for Lift off; a FPV drone simulator. It has a 3mm screw hole in the mounts so if you want to make your own thumb-stick all you have to is make a thread 3-4mm deep thread to interface it. I recommend to run a 3mm through the hole first to make it easier to screw in the piece. I also made a curved connector not in the picture
Print instructions print the thumb stick upside down along with the mount with supports
Descripción original del autor, publicada en Printables.
