Flying Saucer UFO for Bellamys3DPrints Alien
Collaboration with Bellamys3DPrints (https://thangs.com/designer/Bellamys3DPrints) and his cute Little Flexi Alien (https://than.gs/m/975163)!
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Jouni A.
Archivos (6)
- Flying Saucer UFO for Bellamys3DP Alien - Body.stl STL · 6,5 MB
- Flying Saucer UFO for Bellamys3DP Alien - Dome Ring.stl STL · 1,2 MB
- Flying Saucer UFO for Bellamys3DP Alien - Glass Dome Normal.stl STL · 744 KB
- Flying Saucer UFO for Bellamys3DP Alien - Glass Dome Vase Mode.stl STL · 590 KB
- Flying Saucer UFO for Bellamys3DP Alien - Main Body.stl STL · 6,5 MB
- Flying Saucer UFO for Bellamys3DP Alien.3mf 3MF · 2,4 MB
- Categoría
- Miniaturas
- Formatos
- STL, 3MF
- Descargas
- 228
- Publicado
Sobre este modelo
Collaboration with Bellamys3DPrints (https://thangs.com/designer/Bellamys3DPrints) and his cute Little Flexi Alien (https://than.gs/m/975163)!
This flying saucer has print in place unfolding landing gears and landing gear locks. The top dome swivels up and down.
Printing tips The Dome Ring should be printed in PETG because of the snap-in hinge.
There are two versions of the dome, normal and vase mode (although the vase mode version is easier to print normally too without supports). When printing normally, use 0% infill, 1 perimeter/wall and no bottom layers. When printing vase mode, set bottom layers to 0.
Assembly tips Push and snap the dome into the dome ring while aligning the four bumps in the ring and the dome. Then push the ring hinge into the slot on the saucer body. Pliers help push the hinge prongs in!
Descripción original del autor, publicada en Thangs.
