Fish Scale Lamp
There are two configurations of this model you can make. Each one will require six bottom panels and six top panels. Tree supports were used when printing the lamp center part. I would suggest using z-hop when printing the frame part. Each piece was printed with 5% infill, a .2mm layer height, at 30
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a Chris B.
Archivos (7)
- bottom panel.stl STL · 186 KB
- lamp center.stl STL · 2,6 MB
- top pannel .stl STL · 240 KB
- lamp base.stl STL · 149 KB
- lamp frame.stl STL · 166 KB
- lamp top.stl STL · 13 KB
- led holder.stl STL · 179 KB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 58
- Publicado
Sobre este modelo
There are two configurations of this model you can make. Each one will require six bottom panels and six top panels. Tree supports were used when printing the lamp center part. I would suggest using z-hop when printing the frame part. Each piece was printed with 5% infill, a .2mm layer height, at 30mm/s. You can use any standard led tealight or rgb tealight.
Descripción original del autor, publicada en Thangs.
