Filament Spool Holder - Bearings and custom width

Low profile filament spool holder, for when you want your filament sitting next to your printer, and don't take up a lot of space. Use 4 skatebearings (inner diameter of 8 mm) and press them onto the stud - (if very tight, sand a little bit). These can be found very cheaply on ebay. Use the screw to adjust width. Secure knob with glue. The design should fit most spools - write me a comment if you have any questions or suggestions. Happy printing <3 https://youtu.be/aCje9zBBtpw Parts: Resolution: 0.2 mm - 20-30% infill Screw: Resolution:0.1 -0.15 mm - 30-50% infill UPDATE 4TH SEPTEMBER 2017: The standart screw/base can hold filament spools of 100 mm in width. I've added a longer version of the base and screw to accommodate user requests for longer screw/base. This allows for 150 mm spoolwidth. UPDATE 4TH JUNE 2019: Per request I've added a mini version, for smaller spools. This has a slightly shorter base, and the with between the pegs for the bearings has been reduced.