Filament guide for Ender 3 V3 KE / SE w/ filiment runout mount.
por bob bob en Thingiverse
I liked the filament guide https://www.thingiverse.com/thing:6905590 but there was nothing to keep the filament in the wheel, and it would pop out if there was slack in the line. I also wanted to use a 608 bearing to support the wheel for smoother motion. There is a new wheel and a center gap...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a bob bob.
Archivos (4)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
I liked the filament guide https://www.thingiverse.com/thing:6905590 but there was nothing to keep the filament in the wheel, and it would pop out if there was slack in the line. I also wanted to use a 608 bearing to support the wheel for smoother motion. There is a new wheel and a center gap filler so you can still use the original pin. An M5 screw and nut should also work. I edited to two parts to fix this issue. Supports are not need for the wheel, but they are for the base/tower. The little sitting 2d man is not included in this project. If you want the pulley on the far right side in the image, you can get my remix at https://www.thingiverse.com/thing:7419584.
Descripción original del autor, publicada en Thingiverse.
