FIDO - Felines In, Dogs Out - Door holder / prop / latch
Keep dogs out while letting cats through. Just slip FIDO over your door knob (or lever) and latch it into place. You can adjust the latch based on the relative sizes of your cats and dogs. Even if you're not trying to keep a dog out, FIDO is a great way to compromise with your cat who hates closed d
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicioneslegalcode
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Jeremy D.
Archivos (2)
- FIDO - Anchor.stl STL · 79 KB
- FIDO - Latch.stl STL · 57 KB
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 260
- Publicado
Sobre este modelo
Keep dogs out while letting cats through. Just slip FIDO over your door knob (or lever) and latch it into place. You can adjust the latch based on the relative sizes of your cats and dogs. Even if you're not trying to keep a dog out, FIDO is a great way to compromise with your cat who hates closed doors.
Design - Holds most doors slightly ajar - Easy to latch and unlatch from either side of the door - Adjustable width with satisfying snap-in latch - Optimized for printing using just 12 grams of filament and no supports
Print settings - 4 walls recommended for strength of the latch piece - Tested with PLA and PLA+, but would also work great in PETG or other non-brittle filaments
Descripción original del autor, publicada en Thangs.
