Fiament Joiner Jig
por neil richards en MyMiniFactory
Having lots of short pieces of filament left over at the end of spools i decided to
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a neil richards.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 681
- Publicado
Sobre este modelo
Having lots of short pieces of filament left over at the end of spools i decided to try and join them together, after looking around on YouTube and not being able to do many successfully. After looking around i thought i would have a try to make something
You will need a length of Bowden tube and 2 fittings i used the spare fitting i got with the printer and the old one from the extruder upgrade.
This is only recommended for short pieces if filament.
Just put the two ends in and heat the middle of the tube then push together and let it cool down. DO NOT pull the filament, you will have to push it through the tube. After the join is through you can then start to pull.
If you like this please leave a tip to help support my filament fund so i can keep testing
Descripción original del autor, publicada en MyMiniFactory.
