Ferris Wheel of Death
por Wayne Jordan en MyMiniFactory
***PLEASE NOTE THAT IF MULTIPLE PRINTS OF THE SAME PARTS ARE NEEDED, I HAVE ONLY UPLOADED 1 STL OF EACH***
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Wayne Jordan.
Archivos (27)
- 2 x Cap.stl STL
- Base.stl STL
- Bottom.stl STL
- Brace.stl STL
- Crank Gear.stl STL
- Crank Spindle.stl STL
- Crank.stl STL
- Gear Round Hole.stl STL
- Gear Support 1.stl STL
- Gear Support 2.stl STL
- Gear Support.stl STL
- Gear with Slot.stl STL
- Gear With Square Hole.stl STL
- Handle.stl STL
- Small Gear.stl STL
- Spacer.stl STL
- Spindle.stl STL
- Support Frame.stl STL
- Washer.stl STL
- Wheel Frame Round Hole.stl STL
- Wheel Frame Square Hole.stl STL
- X12 Pegs.stl STL
- X12 Seats.stl STL
- X2 Wheel Gear.stl STL
- X2 Wheel Spindle.stl STL
- X4 Caps.stl STL
- X4 Wheel Side.stl STL
- Categoría
- Varios
- Formatos
- STL
- Descargas
- 142
- Publicado
Sobre este modelo
***PLEASE NOTE THAT IF MULTIPLE PRINTS OF THE SAME PARTS ARE NEEDED, I HAVE ONLY UPLOADED 1 STL OF EACH***
This project has taken a long time to complete. Bad design decisions and complications meant that the wheel wouldn’t work. After various attempts to correct the problem, I eventually went back to the drawing board and started again.
I have written a full assembly instruction manual to help you put the model together. I would advise you to look at this before printing the parts so that you know what is needed.
As a lot of you will know, different printers, filaments and setting produce different results, so it is extremely difficult to ensure all the parts will fit perfectly when dealing with small tolerances. Because of this, some filing/sanding will be required to make the parts fit properly and some superglue will be required for some parts.
If you are looking for a quick easy model to print and assemble, this is possibly not the model for you.
One last thing: if this was a real Ferris wheel… I wouldn’t ride it.
https://youtube.com/shorts/ATWBIAWIFyo
Descripción original del autor, publicada en MyMiniFactory.
