Falcon Clamp
por Troy Mackay en MyMiniFactory
Print in place design using a novel planetary gearbox which allows for solid sun and planet gears common to both stages with crazy gear ratios possible.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Troy Mackay.
Archivos (1)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 651
- Publicado
Sobre este modelo
Print in place design using a novel planetary gearbox which allows for solid sun and planet gears common to both stages with crazy gear ratios possible.
The default settings allow for a layer height of 0.2 which corresponds to the gap between the ring gears. Make sure this one-layer gap is preserved when slicing. Separate after printing with a sharp tool before attempting to turn the gears. An M8 nut, bolt and wrench might come in handy to "crack" the gears loose.
Descripción original del autor, publicada en MyMiniFactory.
