Ergo Utility Knife/Blade Holder w/sheath
This is an ergonomic utility blade holder modeled to fit a standard Stanley blade. It does not need screws as the head of the holder has a small latch that bends down allowing to slide in the blades. Light duty use only.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesnon commercial licence
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Jaime S.
Archivos (4)
- sheath.stl STL · 221 KB
- sheath beltclip.stl STL · 239 KB
- Grip (2).stl STL · 121 KB
- Middle (1).stl STL · 255 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 220
- Publicado
Sobre este modelo
This is an ergonomic utility blade holder modeled to fit a standard Stanley blade. It does not need screws as the head of the holder has a small latch that bends down allowing to slide in the blades. Light duty use only.
Prints in 3 pieces as pictured and snaps together by contact, you can put a tad of glue in the holder to secure everything in place. No supports needed. Make sure you have a good first layer so that the blade holder latch does not fuse. My slicer makes a 0.5 width first layer by default so i changed it to 0.42 and the clearence is perfect. Use extra walls and over 25% infill to have a firm piece.
Update: Added 2 sheath options; lid only cover & belt clip holster;
Descripción original del autor, publicada en Thangs.
