EQ6-r accessory tray for tripod spreader
Fits on the EQ6-r Stock spreader, fits in the two 2" holes for stability, tested on the original spreader (with the high arch) and newer ones with the low arch (2023 model)
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Oddity3d.
Archivos (2)
- eq6tray.stl STL · 97 KB
- tray v5_no_support.stl STL · 180 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 16
- Publicado
Sobre este modelo
Fits on the EQ6-r Stock spreader, fits in the two 2" holes for stability, tested on the original spreader (with the high arch) and newer ones with the low arch (2023 model)
The No_support one is flat and relies on the arch to stop it moving - not as stable, but quicker and easier to print, I recommend using the normal one and spending the time to print it with support, it's much better.
Normal one requires a lot of support but is worth it for stability considering what might go into it. Took me 9 hours in ASA, so you can probably do it in 6-7 hours in PLA, My tripod stays out all year though so I just leave it on there and used abs/asa
Descripción original del autor, publicada en Thangs.
