Epoxy Mixing Tool
por Andy Holzrichter en Thingiverse
I needed something to mix some epoxy. Printed in PLA 2 wall 2 top 2 bottom and 10% infill since I didn't need much strength. used PLA since I was told it doesn't stick as bad to epoxy. Haven 't tested it yet.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Andy Holzrichter.
Archivos (1)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 2
- Publicado
Sobre este modelo
I needed something to mix some epoxy. Printed in PLA 2 wall 2 top 2 bottom and 10% infill since I didn't need much strength. used PLA since I was told it doesn't stick as bad to epoxy. Haven 't tested it yet.
Descripción original del autor, publicada en Thingiverse.
