Ender 3 V2 V-Slot Covers

09.01.2020 Added another version of the V-Slots

v2. Flush

A Flush and snug(gier) fit than the original.

Filenames: ver2_Ender3_V2_V-Slot-***.stl,...

v1. Raised bed.

For a raised bed the strips are flipped over. Note however that they are not the same as the v2. They've been redimensioned to get the raised bed effect.

Filenames: ver1_Ender3_V2_V-Slot-***.stl,...

This is a remix from ximes and originally from nicocazza's V-Slot covers.

Original print was too tight for my Ender 3 V2 (beacuse i wanted the strips to be slightly above the bed), so i I adapted the inserts by shaving off 0.2mm on either side of the grip face, changed the lengths for my setup, and trimmed the edges to better accommodate the stepper motor,...

Note, some strips (having the same length) are naturally interchangeable but i nonetheless labelled them.

If you need help figuring out where each strip goes, use the placement guide (pdf).