Ender 3 (V2&PRO) CR Cable Guide for Direct Drive
por George en Printables
Ender 3 (V2&PRO) and CR series extruder wires cable guide for direct drive conversion.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a George.
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 2,461
- Publicado
Sobre este modelo
After I convert my printer to direct drive my extruder cables were touching the Z rods. I don't like cable chains so I need a solution for cable management. The guide has a 90 degrees angle in order to better route the wires and it is mount on the old extruder plate with 2 M3x8 screws from underneath (you could use nuts and washer but I didn't find necessary). Secure the cables with some zip ties and your are done! Updates: 25.02.2022 v3.0 - discovered the cable guide will touch the upper left z lead screw holder and reposition the cable channel.
Descripción original del autor, publicada en Printables.
