Ender 3 S1 cable holder/guide | Pro | laser modul
por Bananenminister en Printables
This is an alternative vertical cable guide for the Ender 3 S1 and S1 Pro. V04 enables the use of the laser holder.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Bananenminister.
Archivos (4)
- Categoría
- Para tu impresora
- Formatos
- STL, ZIP
- Descargas
- 11,941
- Publicado
Sobre este modelo
Be one of ten who leave a Like at Printables and support me with it :) The new version 04 allows to use the original holder of the laser module. For the assembly, the extruder must be disassembled by means of 4 screws and additionally 2 screws of the original cable holder. V3.1 and V3.2 are a simple design - plug & play without disassembly of the extruder. Of these two models, I personally prefer V03.1 as it is the easiest to assemble. The brackets have been designed to use the full installation space of 220x220x270mm. If the part helps you, I would be very happy about a make :) Printer: Creality Ender 3 S1 Pro Walls: 3 Filling 20% for V04
Do not forget to also install the cable guide for the heating bed cable.
Check out my other designs too!
Descripción original del autor, publicada en Printables.
