Ender 3 pressure fitting fix
por Michael Scholtz en Thingiverse
This should fix a common problem people have with the Ender3 where the PTFE tube pops off. it clips around the pressure fitting to hold it tight. There are 3 different sizes for each side. 1mm 1,5mm 2mm this is because I don't expect them to all be the same you don't need to force it. You just want.
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Michael Scholtz.
Archivos (8)
- pressure_fitting_clip_15mm.stl STL · 120 KB
- pressure_fitting_clip_20mm.stl STL · 121 KB
- pressure_fitting_clip_10mm.stl STL · 113 KB
- pressure_fitting_clip_hotend_15mm.stl STL · 123 KB
- pressure_fitting_clip_hotend_10mm.stl STL · 115 KB
- pressure_fitting_clip_hotend_20mm.stl STL · 124 KB
- 1_pressure_fitting_clips_cura.gcode GCODE · 279 KB
- 2_pressure_fitting_clip_hotend_cura.gcode GCODE · 287 KB
- Categoría
- Para tu impresora
- Formatos
- STL, GCODE
- Descargas
- 145,168
- Publicado
Sobre este modelo
This should fix a common problem people have with the Ender3 where the PTFE tube pops off. it clips around the pressure fitting to hold it tight. There are 3 different sizes for each side. 1mm 1,5mm 2mm this is because I don't expect them to all be the same you don't need to force it. You just want to stop the fitting from being able to depress. More about 3D printing - support more development by subscribing to this channel https://www.youtube.com/michaelscholtz1
Descripción original del autor, publicada en Thingiverse.
