Elden Ring- Morgott/Margit
por MynE en MyMiniFactory
Approximately 1:10 statue of Morgott/Margit. The pose for this model references the Playstation trophy art upon defeating
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a MynE.
Archivos (49)
- Base Back.stl STL
- Base Front Fixed.stl STL
- Cloak 1.Stl STL
- Cloak 10.Stl STL
- Cloak 11.Stl STL
- Cloak 12.Stl STL
- Cloak 13.Stl STL
- Cloak 14.Stl STL
- Cloak 15.Stl STL
- Cloak 16.Stl STL
- Cloak 17.Stl STL
- Cloak 2.Stl STL
- Cloak 3.Stl STL
- Cloak 4.Stl STL
- Cloak 5.Stl STL
- Cloak 6.Stl STL
- Cloak 7.Stl STL
- Cloak 8.Stl STL
- Cloak 9.Stl STL
- hair.stl STL
- Head Horn 1.Stl STL
- Head Horn 10.Stl STL
- Head Horn 11.Stl STL
- Head Horn 2.Stl STL
- Head Horn 3.Stl STL
- Head Horn 4.Stl STL
- Head Horn 5.Stl STL
- Head Horn 6.Stl STL
- Head Horn 7.Stl STL
- Head Horn 8.Stl STL
- Head Horn 9.Stl STL
- head.stl STL
- Left Arm.stl STL
- Left Leg.stl STL
- Right Arm.stl STL
- Right Leg.stl STL
- Rope Left.stl STL
- Rope Right.stl STL
- Shoulder Cloak.stl STL
- sword.stl STL
- Tail Horn 1.Stl STL
- Tail Horn 2.Stl STL
- Tail Horn 3.Stl STL
- Tail Horn 4.Stl STL
- Tail Horn 5.Stl STL
- Tail Horn 6.Stl STL
- Tail Horn 7.Stl STL
- tail.stl STL
- torso.stl STL
- Categoría
- Miniaturas
- Formatos
- STL
- Descargas
- 5,371
- Publicado
Sobre este modelo
Approximately 1:10 statue of Morgott/Margit. The pose for this model references the Playstation trophy art upon defeating Morgott the Omen King.
Please read the assembly.pdf for details on printing this model. TEST FIT EVERYTHING prior to painting! I needed to sand some parts in order to fit them together and have compensated for it in this version, however, be pre-warned that you may need to sand the connections.
Due to the nature of the design and character, the tolerances on some keys (namely cloaks) are really tight, and may not be suitable to be downscaled. You may need to sand A LOT in order to fit it together if you decide to print this model smaller. Also be careful with the cloaks, as they do have some fragile bits on the end and some of them are fairly thin.
Descripción original del autor, publicada en MyMiniFactory.
