Ecx torment front/rear control arm
por Coyledesigns en Thingiverse
this replacement part is for the front or rear suspension control arm and is actually stronger than the original part! to print it takes about 20 mins and i suggest that you use PETG for top strength and durability. print at 50% or more infill. no brim or support needed. prints in 20 minutes if you.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Coyledesigns.
Archivos (1)
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
this replacement part is for the front or rear suspension control arm and is actually stronger than the original part! to print it takes about 20 mins and i suggest that you use PETG for top strength and durability. print at 50% or more infill. no brim or support needed. prints in 20 minutes if you run into any problems, please feel free to tell me and i can help.
Descripción original del autor, publicada en Thingiverse.
