Earring and Necklace Holder Remix
por Joseph Mauldin en Thingiverse
I just remixed this so I could print with no supports. Also printed some parts on my resin printer (Mars 5 Ultra). The left and right side labeled indent has a 2mm alignment space to insert the middle tray into, which will require glue. NO supports needed. The left and right side labeled space...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Joseph Mauldin.
Archivos (17)
- Hanger.stl STL · 2,4 MB
- Necklace_hanger.stl STL · 1,4 MB
- left_side_with_space.stl STL · 12,7 MB
- right_side_with_space.stl STL · 14,2 MB
- left_side_with_indent.stl STL · 12,3 MB
- right_side_indent.stl STL · 14,2 MB
- divider.stl STL · 23,7 MB
- middle_solid.stl STL · 36,3 MB
- middle_1_divider.stl STL · 4,2 MB
- middle_2_divider.stl STL · 4,8 MB
- rod.stl STL · 148 KB
- End_Cap.stl STL · 1,2 MB
- middle_supported.stl STL · 101,1 MB
- middle_1_divider_supported.stl STL · 98,6 MB
- middle_2_divider_supported.stl STL · 98,6 MB
- rod_and_end_caps_supported.stl STL · 18,2 MB
- 2_each_hanger_supported.stl STL · 46,8 MB
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
I just remixed this so I could print with no supports. Also printed some parts on my resin printer (Mars 5 Ultra). The left and right side labeled indent has a 2mm alignment space to insert the middle tray into, which will require glue. NO supports needed. The left and right side labeled space should just slide over the middle tray section without the need for glue unless you want. Also added some dividers for the middle tray. Also included the divider stl in case someone would like to place more, less, or off centered. All the files can print with NO support just really depends on your printer and bed adhesion. Also including the pre-supported files for a resin printer
Descripción original del autor, publicada en Thingiverse.
