E3Dv6 Bowden X-carriage mount v2 for Prusa i3

This is 'Version 2' of the popular E3Dv6 Bowden X-carriage mount for Prusa i3. https://youtu.be/BtmDortWBnY If you have a Prusa i3 and are upgrading your hotend to an E3Dv6 (Lite and clone compatible) with Bowden, then you'll need this hotend mount for your X-carriage. As this design clamps the hotend to the mount, there's no chance of a wobbly hotend. Cooling has been incorporated into this version, rather than a bolt-on after thought. This updated design removes the clutter around the hotend so you can view the printing unobstructed. A 50mm Radial/Blower fan is utilized to provide ample cooling for your prints resulting in sharp and detailed finishes. - 50mm Blower Fan - Genuine E3Dv6 or E3Dv6 Clone (1.75mm long)

3 Parts - the Mount, Clamp and Duct. To clamp the E3D hotend, you'll need 2 x M4 screws with 20mm length and 2 x M4 nuts. For the Duct, you'll need 2 x M3 screws with 6mm to 10mm length For the Blower fan, you'll need 1 x M3 screw with 25mm length and 1 x M3 nut. Note: If your X-axis end-stop is on the right hand side, you'll lose approximately 10mm on the X-axis because the blower fan is quite long. Inductive sensor option - check the remixes section :) Duct v1.1 added to support E3D v6 block with silicone sock. Enjoy this design? Consider supporting me on Patreon: https://www.patreon.com/Tech2C