Duck Headphone Hanger
por Alejandro Argandona en Thingiverse
Made this for my sis to hang her headphones. A lot of hangers on thingiverse are great and waste less filament, but I wanted to make her something special. Printed at 0.12, 10% infill. No supports, most printers should handle the bridging on the notches for the screws, and I left room for some...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Alejandro Argandona.
Archivos (1)
- Categoría
- Organización
- Formatos
- OBJ
- Descargas (todas las plataformas)
- 74,616
- Publicado
También en
Sobre este modelo
Made this for my sis to hang her headphones. A lot of hangers on thingiverse are great and waste less filament, but I wanted to make her something special. Printed at 0.12, 10% infill. No supports, most printers should handle the bridging on the notches for the screws, and I left room for some sagging. Holds my big MDR-Z7s no problem, you could scale down if you have smaller cans. You can fix it to the wall with one or two screws, nails or some heavy duty double sided tape. UPDATE: Fixed a problem that base was not completely flat.
Descripción original del autor, publicada en Thingiverse.
