Dremel 4000 Wall mount with drill tool bits storage

Dremel 4000 Wall mount with drill tool bits storage. The Dremel tool can be stored either way up/down depending on your preference. An additional section can be printed to expand your wall mount if required and can be mounted to the right and/or to the left of the Main unit. Prints without supports. (Will require 6mm x 2mm strong magnets) I have added some tabs that can be used to glue into place of magnets if you prefer something more permanent. (There is a separate file for a Dremel 3000 which is untested by me as I don't own one. Feedback welcomed) *Update: Peg Board adaptors have been added. These are untested as I don't have a Peg Board. You will need to screw them into the Main wall mount at the top and also add the spacers at the bottom. **Update: Dremel original case holder Extension. To be attached to the Left side. Can be mirrored in Slicer to attach to the right if preferred. I would recommend gluing this one on as it could be a bit too heavy for the magnets alone. (Print using Brim as surface contact is low)