Dread Pirate Roberts Sword
por Voxel en Printables
Dread Pirate Roberts rapier sword from The Princess Bride
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Voxel.
Archivos (18)
- blade_f1.stl STL · 185 KB
- blade_f2.stl STL · 155 KB
- blade_f3.stl STL · 116 KB
- blade_f4.stl STL · 375 KB
- blade_b1.stl STL · 50 KB
- blade_b2.stl STL · 294 KB
- blade_b3.stl STL · 155 KB
- blade_b4.stl STL · 170 KB
- blade_b5.stl STL · 352 KB
- blade_joint.stl STL · 6 KB
- guard1.stl STL · 15,1 MB
- guard2.stl STL · 15,1 MB
- guard_joint.stl STL · 6 KB
- grip.stl STL · 517 KB
- ring.stl STL · 776 KB
- pommel.stl STL · 2,6 MB
- blade_full.stl STL · 1,2 MB
- blade_half.stl STL · 622 KB
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas
- 1,787
- Publicado
Sobre este modelo
Dread Pirate Roberts rapier sword from The Princess Bride Printed in PETG and 0.2 layer height. Supports only needed for the pommel and the guard. Blade pieces are numbered in the upper side: Front[1-4] & Back[1-5]. You need 5 joints for the guard (guard_joint) and 16 for the blade (blade_joint). Once assembled, It measures 100 cm long from the tip of the blade to the pommel. The blade is very thin and flexible (only perpendicular to the sharp edge), so it bends a bit if you turn the sword parallel to the ground. Sanding, cyanoacrylate, sanding, more sanding, painting, ironed craft foam strip (or leather) and......As you wish. Update 03/07/2019: Added blade_full and blade_half to allow further customization on small printers. You can find the sheath here: https://www.printables.com/model/180517-dread-pirate-roberts-sword-sheath And the belt buckle: https://www.printables.com/model/180521-dread-pirate-roberts-belt-buckle
Descripción original del autor, publicada en Printables.
