Door Retaining Catch
por Zac Simmonds en Thingiverse
A smaller version of my other latch, has a softer snap action and is generally smaller. Print in place, no supports needed. Update 14/01/2021: Removed some material from the female side clip, it is now a little more snappy without being too strong. Update 05/02/2021: Please orientate the part so it.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Zac Simmonds.
Archivos (8)
- Male_Pin_Only.stl STL · 148 KB
- Version_2_Complete.stl STL · 398 KB
- Right_Angle.stl STL · 324 KB
- Weaker_Clip_Female_Side_Only.stl STL · 253 KB
- Female_catch_only_re-upload_due_to_failure.stl STL · 251 KB
- Extremely_Weak_Clamp_Female_Side_Only.stl STL · 361 KB
- Right_Angle_Extremely_Weak_Clamp_Female_Side_Only.stl STL · 450 KB
- Right_Angle_Male_Pin_Only.stl STL · 213 KB
- Categoría
- Varios
- Formatos
- STL
- Descargas
- 45,596
- Publicado
Sobre este modelo
A smaller version of my other latch, has a softer snap action and is generally smaller. Print in place, no supports needed. Update 14/01/2021: Removed some material from the female side clip, it is now a little more snappy without being too strong. Update 05/02/2021: Please orientate the part so it prints flat on the print bed, this is important as it plays to the strength on printer layers instead of against them.
Descripción original del autor, publicada en Thingiverse.
