Do Not Disturb - Miniature Phone Bed

ven your phone needs a bedtime.

DO NOT DISTURB gives your phone a little bed of its own: a rounded frame, a pillow and a sculpted blanket. Set your phone down from above and give scrolling a rest. The blanket is rigid printed plastic; the foot-end opening leaves room for a charging cable.

THREE MAIN PRINTS - Frame with integrated headboard and feet. - Mattress with integrated pillow. - Separate sculpted duvet. Two small fit-test pieces are included in addition to the three main parts. No screws or multi-material printer are required. Print the pieces in your preferred colors; the duvet filenames say Orange, but the blue gallery example uses the same geometry.

SIZE & PHONE FIT Frame: approximately 126 × 212 × 81 mm at 100% scale. Each component fits individually within a 250 × 250 × 250 mm volume. Target phone/case envelope: 86 × 176 × 14 mm. Check your case, camera bump and connector; this is a design envelope, not a universal compatibility claim.

PRINT & ASSEMBLE Start with the included key-and-socket test. The mattress locates on four hidden keys; the duvet seats in its matching sockets. Dry-fit before applying any optional adhesive. Use the top opening to place the phone, not a side-loading motion. Suggested starting settings: PLA, 0.4 mm nozzle, 0.20 mm layers, four walls, five top/bottom layers and 15% infill. Supports may be required, especially under the mattress and raised frame.