DJI Inspire 1 clone quadcopter

por Steve Wagg en Thingiverse

This is my 3D printed Inspire clone. All the original STL files are here but full details on how to build including arduino code etc are at http://www.diyrc.co.uk . All my designs are free to use. If you would like to donate then that's up to you as not everyone can afford it. Watch a youtube video.

Licencia

Uso comercial permitido

CC BY-SA 4.0 — Atribución, compartir igual

Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.

Al descargar aceptas respetar la licencia y dar crédito a Steve Wagg.

Archivos (26)

• center_top_battery_plate_1.stl STL · 70 KB
• center_lower_front1.stl STL · 52 KB
• center_canopy_top_1.stl STL · 476 KB
• center_lower_back_1.stl STL · 197 KB
• inner_leg_housing_2.stl STL · 402 KB
• leg_mover_plate_1.stl STL · 107 KB
• motor_housing_top_4.stl STL · 101 KB
• center_top_battery_XT_clamp_1.stl STL · 33 KB
• Outer_Leg_housing_mirror_2.stl STL · 266 KB
• leg_link_2.stl STL · 67 KB
• center_back_battery_clamp_1.stl STL · 41 KB
• outer_leg_foot_4.stl STL · 90 KB
• Outer_leg_link_1.stl STL · 59 KB
• motor_housing_bottom_4.stl STL · 200 KB
• Outer_leg_link_mirror_1.stl STL · 59 KB
• inner_leg_housing_mirror_2.stl STL · 402 KB
• center_arduino_case_1.stl STL · 52 KB
• center_bottom_body_mount_1.stl STL · 87 KB
• center_bottom_battery_plate1.stl STL · 173 KB
• Outer_Leg_housing_2.stl STL · 266 KB
• center_back_battery_holder_1.stl STL · 142 KB
• center_bottom_battery_spacer_plate1.stl STL · 60 KB
• center_body_connector_1.stl STL · 89 KB
• center_bottom_plate1.stl STL · 217 KB
• gps_canopy_mount_1.stl STL · 61 KB
• center_top_plate1.stl STL · 241 KB

Categoría

Repuestos

Formatos

STL

Descargas

24,303

Publicado

7 de julio de 2015

Copiar enlace