DIY Phone Tripod

To build this model, you will need the following: HARDWARE - Seven: M4x25mm screws

- Seven: M4 nuts

- Three: 24" (610mm) lengths of half-inch PVC pipe

- One: 13" (330mm) length of half-inch PVC pipe

- Three: 36" (915) lengths of half-inch wooden dowels

- (OPTIONAL) One: 15x8mm circular bubble level

- One: M6x180mm partially threaded rod - To build the model without the threaded rod, you will need to print - Tilt_UpperOPTIONAL instead of Tilt_Upper

- Tilt_HandleOPTIONAL instead of Tilt_Handle

- Tilt_RodOPTIONAL

TOOLS - M4 or 5/32" drill bit (and a way to use it)

- Pliers

- Glue of your choice (I strongly recommend CA/superglue)

- Tape of your choice (I recommend masking tape)

PRINTED COMPONENTS (TRIPOD) - One: Upper_Hub

- One: Lower_Hub

- One: PVC_Adapter

- One: Tilt_Block

- One: Tilt_Upper or Tilt_UpperOPTIONAL (See above for which)

- One: Tilt_Handle or Tilt_HandleOPTIONAL (See above for which)

- One: Tilt_RodOPTIONAL (Only if not using the M6x180mm rod)

- Three: Upper_Swivel

- Three: Lower_Swivel (This is the only print that will require supports)

- Three: Swivel_Ring

- Three: PVC_Screwhole

- Three: Height_Thumbscrew

- Six: Swivel_Nut

- Six: Swivel_Bolt

PRINTED COMPONENTS (PHONE CLAMP) - One: updated_phone_clamp_lower OR updated_phone_clamp_lower_thicker

- One: updated_phone_clamp_upper OR updated_phone_clamp_upper_thicker - (opt for whichever one suits your phone better)

- One: updated_phone_clamp_threads