Display holder for SR-71 Blackbird
por Joachim Schwarz en Thingiverse
This is a holder for the model of an SR-71 Blackbird. Just plug in the rear end of the bird and adjust the jet engine supports. It is a little tricky to scale the holder. Just print out the SR-71 (I used this model: https://www.thingiverse.com/thing:5508640/files). I used the scale factor 250 %...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Joachim Schwarz.
Archivos (1)
- Categoría
- Varios
- Formatos
- STL
- Descargas
- 2
- Publicado
Sobre este modelo
This is a holder for the model of an SR-71 Blackbird. Just plug in the rear end of the bird and adjust the jet engine supports. It is a little tricky to scale the holder. Just print out the SR-71 (I used this model: https://www.thingiverse.com/thing:5508640/files). I used the scale factor 250 % because the model was pretty small. Then adjust the holder by measuring the distance the down side of the engines and scale it to the respective value. In short: the size of the holder depends on your model printout size.
Descripción original del autor, publicada en Thingiverse.
