DIN 5 MIDI MALE PLUG connector
por JAKUB KOLČÁŘ en Thingiverse
Hey. If you wanna make MIDI 5 DIN connector for your musical instruments, synths, MIDI keyboards etc, you can use this. Its precise and fits into the female MIDI socket precisely. I use to print it with PLA, but can be printed with PETG or other materials as well. MIDI uses only the 3 pins in the...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a JAKUB KOLČÁŘ.
Archivos (1)
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
Hey. If you wanna make MIDI 5 DIN connector for your musical instruments, synths, MIDI keyboards etc, you can use this. Its precise and fits into the female MIDI socket precisely. I use to print it with PLA, but can be printed with PETG or other materials as well. MIDI uses only the 3 pins in the center. To make it work, I usually take 1.4 mm diameter steel nails, sand the pointy tipy into rounded tip and put them into the three central holes. The pins should extend about 7-8 mm - or be about 2 mm low in the barrel. On the other end I solder wire to them. Tested on real MIDI devices and works. I use this to make MIDI - > TRS adaptors.
Descripción original del autor, publicada en Thingiverse.
