DiM Card Case - Print in place hinge
por Garren en MyMiniFactory
Designed a case for DiM cards. It uses 6x2mm magnets (readily available online) and is meant to be press fit, but you can bore out the hole and use glue.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Garren.
Archivos (4)
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 342
- Publicado
Sobre este modelo
Designed a case for DiM cards. It uses 6x2mm magnets (readily available online) and is meant to be press fit, but you can bore out the hole and use glue.
One model has a circuit design on the top, one does not.
Printing: I printed a .2mm layer height from a .4mm nozzle. My machine is fairly dialed in, but this build should work if yours isn't as dialed in too.
Update: 7/7/21 - Added a new version of each that has a cutout lip to make the case easier to open.
Descripción original del autor, publicada en MyMiniFactory.
