Diamond Christmas Bell
This is the fourth in my 2022 Christmas bell series. It prints quickly and easily. Use a nice medium toned silky, metallic or multicolored filament to show off the geometry - or use translucent filament to make it glow.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Uso comercial permitidoCC BY-ND 4.0 — Atribución, sin derivadas
Puedes imprimirlo y compartirlo sin cambios dando crédito; no se permite distribuir versiones modificadas.
Al descargar aceptas respetar la licencia y dar crédito a Scott M.
Archivos (1)
- Single Diamond Bell v2.stl STL · 3,5 MB
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 253
- Publicado
Sobre este modelo
This is the fourth in my 2022 Christmas bell series. It prints quickly and easily. Use a nice medium toned silky, metallic or multicolored filament to show off the geometry - or use translucent filament to make it glow.
This is based on my closed lattice, spiral and open lattice bells. It's roughly the same size (slightly taller) with a new loop at the top and a new lattice pattern.
Not for commercial use. Please see license agreement.
PRINT SETTINGS - Walls: 0.4 - 0.8 mm (I used 0.4 mm for the clear bell and added an alternating extra line for the opaque bell) - Layer Thickness: 0.15 mm recommended. Anything from 0.1 - 0.2 mm should look good. - Infill: None. Seriously. It doesn't need it. It just adds weight and print time. - Rafts/Brim: I didn't use either. However, the first layer is just a single width circle, so you may need to add a brim or raft. - Supports: None. I designed this to print cleanly without them.
Descripción original del autor, publicada en Thangs.
