Desk Organizer

Desk Organizer — Pen Cup, Clip Tray and Sticky-Note Bay 🖊️

Pens, paper clips and a pad of sticky notes, each with its own spot, in one piece that takes up 178 × 89 mm of desk.

🟩 𝗪𝗛𝗔𝗧 𝗠𝗔𝗞𝗘𝗦 𝗜𝗧 𝗪𝗢𝗥𝗞

▸ 𝗧𝗮𝗹𝗹 𝗣𝗲𝗻 𝗖𝘂𝗽 — 96.5mm high, deep enough that scissors, markers and highlighters stand upright instead of tipping out.

▸ 𝗣𝗮𝗽𝗲𝗿-𝗖𝗹𝗶𝗽 𝗧𝗿𝗮𝘆 — A shallow tray at the foot of the pen cup with a rounded floor, so a single clip slides up and out under a fingertip instead of hiding in a corner.

▸ 𝗦𝘁𝗶𝗰𝗸𝘆-𝗡𝗼𝘁𝗲 𝗕𝗮𝘆 — A walled bay beside the cup holds a pad of sticky notes flat and ready to peel.

▸ 𝗢𝗻𝗲 𝗣𝗶𝗲𝗰𝗲 — Prints upright with no supports, no hardware and no assembly.

▸ 𝗢𝗽𝘁𝗶𝗼𝗻𝗮𝗹 𝗖𝗼𝗹𝗼𝗿 𝗕𝗮𝗻𝗱 — Plate 1 swaps to a second color for a band around the base. Plate 2 is the same model in one color.

🟩 TWO PLATES, PICK ONE

▸ With Color Band: 3h 38m and 129.43 g, 43.40 m of filament, roughly $3.88, 2 filament swaps

▸ No Color Band: 3h 26m and 125.53 g, 42.09 m of filament, roughly $3.77, no swaps

🟩 𝗣𝗥𝗜𝗡𝗧 𝗦𝗘𝗧𝗧𝗜𝗡𝗚𝗦

No supports · no brim · 0.20mm layer height · Z anti-aliasing · 10% gyroid infill · 4 walls · 5/3 top and bottom · PLA · 220 °C nozzle · 60 °C bed

🟩 𝗧𝗛𝗘 𝗡𝗨𝗠𝗕𝗘𝗥𝗦

177.8 × 88.9 × 96.5mm. One piece.

Print it in PLA, PETG or any other filament you like. The 3MF is set up for PLA, and the one in the photos is black and lime PETG. The band is a filament swap from 6.8 to 16mm, so any two colors work. If your slicer has no Z anti-aliasing setting, just print it without. Happy printing! 🖊️