Desk Cable Holder – 5 Slots, No Adhesive

A one-piece weighted desk cable holder that keeps up to five charging, USB, and audio cables parked exactly where you left them — no adhesive, no screws, no clips to lose. Drop each cable into its own 8 mm rounded-bottom groove and it stays put; lift it out with one hand when you need it. The solid 160 mm bar is heavy enough to stay on the desk when you pull a cable, and the flat base sits neatly behind a laptop, on a nightstand, or beside a charger. Features: One piece, no assembly — no adhesive pads, no screws, no hardware. Five 8 mm grooves with rounded bottoms — fits most USB, charging, and audio cables without pinching them. Weighted by design — the solid bar stays put when you pull a cable out, unlike light clip-on holders that lift off the desk. Cable-friendly — rounded groove bottoms cradle cables instead of kinking them at a sharp corner. Support-free — all walls vertical, printed flat on its base. Print on demand in any color to match your desk setup. Dimensions: 160 x 45 x 24 mm (fits most print beds). Grooves: 5, each 8 mm wide, 12 mm deep, rounded bottom. Minimum wall: 22 mm between grooves, 12 mm solid base below grooves, 16 mm end margins. Print settings: PLA (PETG also fine), 0.2 mm layer height, 3 walls, 15% infill, no supports, print flat on the base.