Deathstroke Mask with two eyes
por peter snyder en Thingiverse
Edit 4/28/2017 : I printed it out at 100% and it was a little small for my head. I would recommend printing it out at about 110% but I'm 6'5" tall so my head might be a little bigger than some. I had a couple of requests to make a Deathstroke mask with two eyes. Well here it is...enjoy This mask...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a peter snyder.
Archivos (9)
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas (todas las plataformas)
- 42,803
- Publicado
También en
Sobre este modelo
Edit 4/28/2017 : I printed it out at 100% and it was a little small for my head. I would recommend printing it out at about 110% but I'm 6'5" tall so my head might be a little bigger than some. I had a couple of requests to make a Deathstroke mask with two eyes. Well here it is...enjoy This mask was sized to fit an adult male but but do size accordingly. I will not make one with three eyes so don't ask :)
Descripción original del autor, publicada en Thingiverse.
